Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
5. Remove the lockplate, canceling cam, upper bearing preload spring, and the thrust washer from the steering column/shaft.
6. Remove the hazard warning switch knob. Press the knob inward and remove it from the column by turning it counterclockwise.
7. Remove the turn signal/wiper/cruise control stalk by pulling it out straight from the column. Wiper must be in the off position.
8. Disconnect the turn signal wire harness connector from the bracket.
Taped Turn Signal Switch Wire Harness Connector
CAUTION: Wrap tape around the turn signal switch wire harness connector to prevent it from becoming entangled during removal.
Turn Signal Switch Retaining Screw
9. Remove the turn signal switch retaining screws, dimmer switch actuator arm, to remove the switch. Guide the switch straight up and out of the
steering column.
10. Remove the wiper switch wire harness and all the other wire harnesses located within the steering column.
11. Insert the ignition switch key into the key/ lock cylinder and turn to the ON position.
CAUTION: Do not attempt to remove the key warning buzzer switch and contacts separately. If separated, the contacts can detach and drop into
the steering column.
