Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
Seals and Gaskets: Service and Repair
Manual Valve Shaft Seal Replacement
1.
Remove neutral safety switch and disconnect transmission shift lever, then remove oil pan and valve body, refer to VALVE BODY.
Fig. 13 Park rod bracket
Fig. 14 Park rod
2.
Remove bolts attaching park rod bracket to case, Fig. 13, then remove park rod from shift sector, Fig. 14.
Fig. 15 Cutting spacer sleeve
3.
Cut spacer sleeve with chisel and remove it from manual valve shaft, Fig. 15. Remove pin from shaft and sector with pin punch, then remove shaft
and sector from case.
4.
Pry shaft seals out of case. Inspect manual valve shaft and sector and replace either if worn of damaged.
