Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
Power window
8. Remove the window regulator rivets by knocking out the rivet center with a punch. Then drill out the rivet body with a 1/4 inch drill bit.
9. Remove the window regulator.
DOOR GLASS-VENT WINDOW-REGULATOR INSTALLATION
1. Install the regulator in the door. Secure the regulator with new rivets or screws and nuts which are available in a parts kit.
2. Install the window in the door and install the spring washer and nut. The spring washer must be used to maintain proper tension on the stud nut.
3. Tighten the door glass stud nut to 6 Nm (4 ft-lbs) torque.
4. Install the vent window and channel.
5. Install the glass channel bottom screw. Tighten the screw to 9 Nm (7 ft-lbs) torque.
6. Attach the plastic water dam sheet to the door panel with 3M 08044 or 08041 adhesive/sealant.
7. Install the trim panel.
VENT WINDOW REPLACEMENT
1. Remove the door trim panel and the plastic water dam sheet.
2. Remove the window channel bottom screw.
3. Remove the vent window frame screws.
4. Tilt the vent window and channel rearward and remove the assembly.
Removing/Installing Vent Window
5. Remove the latch pin and latch.
6. Remove the hinge screw.
7. Remove the pivot nut and spring.
8. Remove the glass from the frame.
9. Position the new vent window in the door and install the hinge screw, pivot spring and nut.
10. Install the window latch and pin.
11. Install the vent window and channel in the door.
12. Install the door glass channel bottom screw.
13. Install water dam sheet and door trim panel.
