Cherokee 2WD L4-150 2.5L VIN P MFI (1991)
Fig. 54 High Pressure Line
7.
Disconnect high pressure line from accumulator block, and cap to prevent dirt entry.
8.
Disconnect supply line from reservoir, and cap to prevent dirt entry. Discard fluid drained from lines.
Fig. 55 Boost Pressure & Fluid Level Switch Connections
9.
Disconnect low pressure switch, modulator boost pressure and fluid level switch wires.
10.
Disconnect front brake lines from outboard side of pressure modulator.
11.
Disconnect brake lamp switch wires.
12.
Remove master cylinder pushrod bolt, then disconnect pushrod from pedal. Discard pushrod nuts, they are not reuseable.
13.
From engine compartment, pull brake hydraulic components and mounting bracket forward until bracket studs are clear of dash. Lift assembly up
and out of engine compartment.
