Cherokee 2WD L4-150 2.5L VIN P MFI (1991)
Brake Disc: Service and Repair
ROTOR REMOVAL 2WD
1. Raise vehicle and remove wheels.
2. Remove caliper.
Rotor And Hub 2WD
3. Remove grease cap.
4. Remove cotter pin and nut retainer.
5. Remove nut lock, bearing nut and front bearing.
6. Remove rotor from spindle.
7. Remove grease seal and rear bearing.
8. Remove rotor shield if necessary.
ROTOR INSTALLATION 2WD
1. Clean and repack bearings with Mopar or equivalent wheel bearing grease. Then coat spindle, bearing races and rotor hub cavity with bearing
grease.
2. Install rear bearing and new grease seal in rotor.
3. Install rotor on spindle.
4. Install front bearing, washer and bearing nut.
5. Install the wheel.
6. Tighten bearing nut to 23-34 Nm (17-25 ft. lbs.) torque while rotating the wheel. Then loosen bearing nut 1/2 turn and retighten to 2 Nm (19 in.
lbs.) torque.
7. Install nut lock and new cotter pin.
8. Coat interior of grease cap with bearing grease and install it in rotor hub.
9. Remove the wheel.
10. Install caliper and reinstall wheel.
11. Lower vehicle.
