Cherokee 2WD L4-150 2.5L VIN P MFI (1991)
Camshaft: Service and Repair
Removal
1.
Drain the cooling system and remove the radiator.
2.
Remove the drive belt(s).
3.
Remove the fuel pump and the distributor and ignition wires.
4.
Remove the cylinder head cover.
5.
Remove the capscrews (1), bridge (2) and pivot (3) assemblies and rocker arms (4). Alternately loosen each capscrew, one turn at a time to avoid
damaging the bridges. Remove the push rods.
NOTE: Position all components on a work bench in the same order as removed to facilitate installation in the original positions.
6.
Remove the hydraulic valve tappets, the pulley (if applicable), vibration damper and timing case cover.
7.
Remove the crankshaft oil slinger and the camshaft sprocket retaining bolt.
