jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Engine - Intermittent No Start/Idle Flare|Page 2256 > < Engine - Intermittent No Start/Idle Flare|Page 2254
Page 9
background image

SRT/TIC INFORMATION

OPERATION DESCRIPTION

OPERATION

TIME

TIC

NUMBER

CO. ACCEL. PEDAL/CABLE MECHANICAL LINKAGE OPERATION - INSPECTION
INC. MS 1700 TEST

0309

0.9

3-735

CO. INJECTION SYSTEM - TEST INC.
ADJUSTMENTS

1238

0.3

*

CO. SENSOR, THROTTLE POSITION -
REPLACE

1816

0.5

1-862

*

Use TIC for the causal part.

FILING INSTRUCTIONS

Record this I.S. Note on the Engine Contents page under Six-Cylinder Engine and file it in the M.R. 244 Manual.

Technical Service Bulletin # 46E426

Date: 871001

Engine - Low Idle Speed, Start, Run & Stall Condition

46E426
OCTOBER 1987
1987 CHEROKEE/ WAGONEER VEHICLES WITH 4.0L ENGINE
ENGINE

Attention: Workshop, Parts Department

LOW IDLE SPEED

Some Cherokee/Wagoneer vehicles equipped with a 4.0L engine may exhibit a start, run and then stall condition during hot ambient temperatures. This
condition could be caused by either an injection system malfunction or an incorrect idle speed setting.

Service correction for this condition requires an injection system test with a MS 1700 tester and repair of any malfunction detected via the tester. If no
malfunction exists or the condition persists after repair, perform the following idle speed adjustment procedure.
ADJUSTMENT PROCEDURE

The engine must be at normal operating temperature, automatic transmission in the PARK position, manual transmission in NEUTRAL and all electrical
accessory switches in the OFF position.

1.

Connect a tachometer to diagnostic connectors D1-1 (+) and D2-7 (-).

Engine - Intermittent No Start/Idle Flare|Page 2256 > < Engine - Intermittent No Start/Idle Flare|Page 2254