jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Engine - Low Idle Speed, Start, Run & Stall Condition|Page 2163 > < Fuel Pressure Test Port|Locations
Page 1
background image

Idle Speed: All Technical Service Bulletins
Engine - Low Idle Speed, Start, Run & Stall Condition

46E426
OCTOBER 1987
1987 CHEROKEE/ WAGONEER VEHICLES WITH 4.0L ENGINE
ENGINE

Attention: Workshop, Parts Department

LOW IDLE SPEED

Some Cherokee/Wagoneer vehicles equipped with a 4.0L engine may exhibit a start, run and then stall condition during hot ambient temperatures. This
condition could be caused by either an injection system malfunction or an incorrect idle speed setting.

Service correction for this condition requires an injection system test with a MS 1700 tester and repair of any malfunction detected via the tester. If no
malfunction exists or the condition persists after repair, perform the following idle speed adjustment procedure.
ADJUSTMENT PROCEDURE

The engine must be at normal operating temperature, automatic transmission in the PARK position, manual transmission in NEUTRAL and all electrical
accessory switches in the OFF position.

1.

Connect a tachometer to diagnostic connectors D1-1 (+) and D2-7 (-).

Engine - Low Idle Speed, Start, Run & Stall Condition|Page 2163 > < Fuel Pressure Test Port|Locations