Cherokee 2WD L6-4.0L VIN S (1998)
Amplifier: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disengage the rear seat cushion latch by pulling upward on the release strap. Tilt the seat cushion forward.
3. Lift the carpeting on the rear floor pan under the left end of the seat cushion as required to access the amplifier.
Amplifier Remove/Install
4. Unplug the two wire harness connectors from the amplifier.
5. Remove the four screws that secure the amplifier to the rear floor pan.
6. Remove the amplifier from the vehicle.
7. Reverse the removal procedures to install. Tighten the amplifier mounting screws to 2.8 N.m (25 in. lbs.).
