Cherokee 2WD L6-4.0L VIN S (1998)
Caliper Installation
3. Install caliper by position notches at dower end of brake shoes on bottom mounting ledge. Then rotate caliper over rotor and seat notches at upper
end of shoes on top mounting ledge.
4. Coat caliper mounting bolts with silicone grease. Then install and tighten bolts to 16 Nm (11 ft. lbs.).
Mounting Bolt Dimensions
CAUTION: If new caliper bolts are being installed, or if the original reason for repair was a drag/pull condition, check caliper bolt length before
proceeding. Bolts must not have a shank length greater than 67.6 mm (2.66 inch).
5. Tighten brake hose fitting bolt to 31 Nm (23 ft. lbs.).
CAUTION: Insure the brake hose is not twisted or kinked and clear of all steering and suspension components.
6. Install wheel and tire assembly.
7. Remove support and lower vehicle.
8. Pump brake pedal until caliper pistons and brake shoes are seated.
9. Fill master cylinder and bleed brake system.
