Cherokee 2WD L6-4.0L VIN S (1998)
either loose or damaged.
6. Secure sensor wire to steering knuckle and body brackets.
7. Route sensor wire forward and behind shock absorber. Then attach sensor wire to spring seat bracket with grommets on sensor wire.
8. Route sensor wire to outer sill bracket. Remove all twists or kinks from wire.
9. Attach sensor wire to sill bracket with grommet. Be sure wire is free of twists and kinks.
10. Verify sensor wire routing. Wire should loop forward and above sill bracket. Loose end of wire should be below sill bracket and towards brake
hose.
11. Seat sensor wire grommet in body panel and clip wire to brake line at grommet location.
12. Connect sensor wire to harness in engine compartment.
