Cherokee 2WD L6-4.0L VIN S (1998)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
Servo Cable To Bellcrank-Removal/Install
2. Using finger pressure only, remove cable connector by pushing connector off the throttle body bellcrank pin. DO NOT try to pull cable connector
off perpendicular to the bellcrank pin. Connector will be broken.
Squeeze Tabs At Cable Locking Plate
3. Two squeeze tabs are located on sides of speed control cable at cable locking plate. Squeeze the tabs together and push cable out of cable locking
plate.
4. Unclip cable from cable guide at valve cover.
5. Disconnect servo cable at servo. Refer to Speed Control Servo-Removal/Installation.
INSTALLATION
