Cherokee 2WD L6-4.0L VIN S (1998)
Automatic Transmission
a. Remove the support cushion bolts and remove the cushion and the support bracket from the transmission (4WD) or from the adaptor bracket
(2WD).
b. On 2WD vehicles, remove the bolts holding the transmission support adaptor bracket to the transmission. Remove the adaptor bracket.
INSTALLATION
Manual Transmission:
a. Install the transmission support bracket to the transmission. Install the bolts and tighten to 46 Nm (34 ft. lbs.) torque.
b. Install the support cushion to the support bracket. Install the nuts and tighten to 75 Nm (55 ft. lbs.) torque.
Automatic Transmission:
a. On 2WD vehicles, position the transmission support adaptor bracket to the transmission. Instal] the bolts and tighten to 75 Nm (55 ft. lbs.) torque.
b. Position the transmission support bracket and support cushion to the adaptor bracket (2WD) or the transmission (4WD). Install the bolts and
tighten to 75 Nm (55 ft. lbs.) torque.
1. Position the crossmember onto the support cushion studs. Install the stud nuts and tighten to 22 Nm (192 inch lbs) torque.
2. Install crossmember-to-sill bolts and tighten to 41 Nm (30 ft. lbs.) torque.
3. Remove the transmission support.
4. Lower the vehicle.
5. Connect negative cable to battery.
