Cherokee 2WD L6-4.0L VIN S (1998)
12.
Remove the three (3) ACM cover screws and then discard the ACM cover (Figure 3).
13.
Disconnect the ACM electrical connector by sliding the white locks rearward and then depressing the locking tabs.
14.
Remove the three (3) ACM attachment nuts (Figure 3).
15.
Remove the old ACM, destroy the old ACM connector pins and then discard the old ACM.
16.
Reinstall the rearmost two (2) ACM cover screws to seal the floor pan.
17.
Disconnect the ACM ground eyelet from the front seat riser just in front of the old ACM location.
18.
Pull the ACM harness and seat belt buckle warning harness under the carpeting and up into the center console area so that the ACM connector and
ground eyelet extend out of the center tunnel cutout.
19.
Locate the provided template on the two (2) right side console support bracket screw holes (Figure 4). Secure the template to the floor pan with
two of the support bracket screws. Install the rear screw first and then install the front screw. Tighten the screws securely.
NOTE:
Trim the carpet and insulation, if necessary, to access the screw hole locations. Do not trim beyond the impression left in the carpet from the console.
