Cherokee 2WD L6-4.0L VIN S (1998)
Power Mirror Switch: Service and Repair
REMOVAL
This procedure covers removal of only the stand alone power mirror switch. Vehicles with power windows and power locks have the a power mirror
switch integral to the Driver Door Module (DDM).
1. Disconnect and isolate the battery negative cable.
Stand-Alone Power Mirror Switch Remove/Install
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the edge of the switch out of the trim panel to release the snap clip
retainers.
3. Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
4. Unplug the power mirror switch wire harness connector.
5. Reverse the removal procedure to install.
