Cherokee 2WD L6-4.0L VIN S (1998)
3. Position accumulator springs and spacers on valve body.
Shift Sector And Manual Valve Alignment
4. Align valve body manual valve with shift sector and carefully position valve body on case.
Transmission Valve Body Bolt Locations
5. Install valve body bolts. Tighten bolts evenly to 10 Nm (7 ft. lbs.) torque.
Installing Transmission Valve Body Oil Tubes
6. Install valve body oil tubes. Be sure tube ends (L) and (M) are installed as shown in.
7. Remove old sealer material from oil pan and transmission case.
8. Clean oil screen and oil pan with solvent (if not done previously). Dry both components with compressed air only. Do not use shop towels.
9. Install new gaskets on oil screen and install screen on case. Tighten screen attaching bolts to 10 Nm (7 ft. lbs.) torque.
10. Apply bead of Threebond"R" Liquid Gasket TB1281, P/N 83504038 to sealing surface of oil pan. Sealer bead should be at least 3 mm (1/8 inch)
wide. Then install oil pan and tighten pan bolts to 7.4 Nm (65 inch lbs.) torque.
