Cherokee 2WD L6-4.0L VIN S (1998)
Fig.14 Rear Wiper Arm
2. Lift the wiper arm pivot cover and remove the retaining nut.
3. Remove the wiper arm from the motor output shaft using a rocking motion.
4. Install the rear wiper arm with the wiper motor in the Park position. Place the rear wiper blade on the glass so that it is parallel to the liftgate glass
opening, and install the wiper arm retaining nut.
Rear Wiper Arm Installation
5. Operate the rear wiper on the wet liftgate glass, then turn the rear wiper switch to the Off position so that the blade moves to the Park position. The
tip of the blade should now be from 27 to 35 mm (1.06 to 1.38 Inch) above the upper edge of the lower liftgate glass seal Check for the correct
wiper arm positioning and readjust if required.
6. Tighten the wiper arm retaining nut to 18 N.m (160 in. lbs.) and close the pivot cover.
