Cherokee 4WD L6-242 40L Brake Fluid Specs | Hydraulic System
Brake Fluid: Service and Repair
NOTE: When filling the brake system with fluid, it is important that both accumulators be full. To do this, simply fill the reservoir to the full level as
indicated on the reservoir. Then start the engine and pump the brakes until the booster pump/motor assembly energizes. Then stop pumping the brakes
and wait until the booster pump shuts off. Then recheck the brake reservoir and add fluid as necessary.
RECOMMENDED FLUID
The only brake fluid recommended for use with the anti-lock system is Mopar brake fluid, or an equivalent fluid meeting SAE and DOT standards
J-1703 and DOT 3.
Use new brake fluid only when adding fluid, refilling the system, or to lubricate parts. Never use reclaimed fluid, fluid not meeting the SAE/DOT
standards, or fluid from a container that has been left open for any length of time.
Fig.39 Fluid Level
FLUID LEVEL
The fluid level indicator mark is on the driver side of the reservoir. Fill the reservoir only to the top of the V-shape MAX indicator mark. Do not
fill the reservoir above this mark. Overfilling could cause overflow and possible reservoir damage when the pump begins cycling.
IMPORTANCE OF CLEAN FLUID
Clean the reservoir cap and exterior thoroughly before removing the cap to add fluid. Any dirt or foreign material entering the hydraulic system
through the reservoir could result in poor brake system performance and possible component failure.
Also check the reservoir filter when servicing the system. Remove and clean the filter with clean brake fluid if necessary.
