Cherokee 4WD L6-242 4.0L VIN M FI (1988)
28.
Install upper bearing race, seat, upper bearing preload spring, canceling cam and lock plate into housing.
Fig. 32 Lockplate removal
29.
Using tool No. J-23653-A, compress lock plate and install snap ring onto steering shaft.
30.
Install lock plate cover.
31.
On models with column shift, install gear selector lever and retaining pin.
32.
On all models, install tilt and turn signal levers.
33.
Install ignition switch as follows:
a.
Insert ignition key, then place lock cylinder in Off-Unlock position.
b.
Position switch slider to Accessory, then back off two clicks to Off-Unlock position.
c.
Insert remote rod into switch slider hole, then install switch onto column jacket.
d.
Move switch downward until remote rod to switch lash is eliminated, then torque switch retaining screws to 35 inch lbs.
34.
Install dimmer switch. Depress switch slightly, then install a 3/32 inch drill bit to lock switch to body. Move switch upward to remove lash
between switch and pivot, then torque switch retaining screws to 35 inch lbs.
35.
Position switch harness protectors, if equipped, over harness, then snap protectors into position on column.
36.
Install steering wheel. Torque steering wheel retaining nut to 25 ft. lbs., then install horn cover.
