Cherokee 4WD L6-242 4.0L VIN S MFI (1992)
4. Connect the radiator and heater hoses to the water pump.
5. Position water pump pulley to water pump hub.
6. If equipped with a water pump mounted fan, install fan and four nuts to water pump hub. If not equipped with a water pump mounted fan, install 4
pump hub bolts. Tighten bolts (or nuts) to 27 N.m (20 ft. lbs.) torque.
Fig. 7 Bracket Mounting Bolts - Typical
7. Position power steering pump bracket to engine. Install bolts E, F and G. Tighten bolts F and G to 38 N.m (28 ft. lbs.) torque. Tighten bolt E to 27
N.m (20 ft. lbs.) torque.
Fig. 6 P.S. Pump Front Mounting Bolt/Locknut - Typical
8. Position power steering pump to mounting bracket. Install pivot bolt B finger tight. Install locknut C and adjustment bolt D finger tight.
9. Install 2 adjustment bolts A finger tight.
10. Install idler pulley
CAUTION: When installing the serpentine engine accessory drive belt, the belt MUST be routed correctly. If not, the engine may overheat due to
the water pump rotating in the wrong direction. Refer to the Belt Routing Label in the vehicle engine compartment.
