jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Power Door Lock Control Module > < Power Door Lock Actuator|Description and Operation|Page 5397
Page 1
background image

Power Door Lock Actuator: Service and Repair

REMOVAL

Front Door

The front door power lock motor is integral to the front door latch unit. If the front door power lock motor is faulty or damaged, the entire latch
unit must be replaced. 

Rear Door

The rear door power lock motor is integral to the rear door latch unit. If the rear door power lock motor is faulty or damaged, the entire latch unit
must be replaced. 

Liftgate
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate.
3. Remove the liftgate trim panel from the lift-gate. 

Liftgate Power Lock Motor Remove/Install

4. Reach through the liftgate inner panel access hole and disconnect the link from the clip on the power lock motor.
5. Remove the two screws that secure the power lock motor to the liftgate inner panel.
6. Pull the power lock motor out through the lift-gate inner panel access hole far enough to access the wire harness connector.
7. Unplug the wire harness connector from the power lock motor.
8. Remove the power lock motor from the liftgate.
9. Reverse the removal procedures to install. Tighten the power lock motor mounting screws to 3 N.m (28 in lbs).

Power Door Lock Control Module > < Power Door Lock Actuator|Description and Operation|Page 5397