Cherokee 4WD L6-4.0L VIN S (1998)
Rear Wheel Speed Sensor
10. Remove bolt attaching sensor to bracket and remove sensor.
Installation
1. If original sensor is being installed, remove any remaining pieces of cardboard spacer from sensor pickup face. Use dry shop towel only to remove
old spacer material.
2. Insert sensor wire through support plate hole. Then seat sensor grommet in support plate.
3. Apply Mopar Lock N' Seal or Loctite 242 to onginal sensor bolt. Use new bolt if original is worn or damaged.
4. Install sensor bolt finger tight only at this time.
Setting Air Gap On Original Rear Sensor
5. If original rear sensor was installed, adjust sensor air gap to 0.92 - 1.275 mm (0.036 - 0.05 in.). Use feeler gauge to measure air gap. Tighten
sensor bolt to 13 Nm (115 in. lbs.).
