Cherokee 4WD L6-4.0L VIN S (1998)
Blower Motor Relay: Service and Repair
REMOVAL and INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Roll the glove box down from the instrument panel.
Blower Motor Relay Remove/Install
3. Reach through the instrument panel glove box opening to locate the blower motor relay.
4. Unplug the blower motor relay from its wire harness connector.
5. Install the blower motor relay by aligning the relay terminals with the cavities in the wire harness connector and pushing the relay firmly into
place.
6. Roll the glove box back up into the instrument panel.
7. Connect the battery negative cable
8. Test the relay operation.