Cherokee 4WD L6-4.0L VIN S (1998)
Glove Box Lamp Switch: Service and Repair
REMOVAL
WARNING: ON VEHICLES EOUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Roll down the glove box from the instrument panel. See Glove Box for the procedures.
Glove Box Lamp And Switch Remove/Install
3. Reach through and above the instrument panel glove box opening upper reinforcement to unlatch and unplug the wire harness connector from the
glove box lamp and switch.
4. Reach through and above the instrument panel glove box opening upper reinforcement to depress the retaining tabs on the top and bottom of the
glove box lamp and switch housing.
5. While holding the retaining tabs depressed, push the glove box lamp and switch unit out through the mounting hole in the instrument panel glove
box opening upper reinforcement.
.
Reverse the removal procedures to install.