Cherokee 4WD L6-4.0L VIN S (1998)
Water Shield Lower Screws Remove/Install
11. Remove the one screw located below the multi-function switch lever that secures the switch water shield and bracket to the steering column.
12. Gently pull the lower mounting tab of the switch water shield bracket away from the steering column far enough to clear the screw boss below the
multi-function switch lever.
13. Lift the water shield and bracket with the multi-function switch away from the steering column far enough to access the two multi-function switch
wire harness connectors. If the vehicle is equipped with the optional tilt steering column, lifting gently upward on the tilt release lever will provide
additional clearance to ease multi-function switch removal.
14. Unplug the wire harness connectors from the multi-function switch.
15. Remove the multi-function switch and water shield from the steering column as a unit.
16. Gently pull the water shield over the hazard warning switch knob and the multi-function switch lever.
17. Reverse the removal and procedures to install.