Cherokee 4WD L6-4.0L VIN S (1998)
Power Steering Pump: Service and Repair
Power Steering Pump Flow Control Valve Replacement
REMOVAL
1. Clean area around fitting to prevent dirt from entering pump. Remove pressure hose from pump fitting.
2. Remove fitting from pump housing. Prevent flow control valve and spring from sliding out of housing bore.
3. Remove and discard O-ring seal.
INSTALLATION
1. Install spring and flow control valve into pump housing bore. Be sure the hex nut end of the valve is facing in toward pump.
2. Install O-ring seal onto fitting.
3. Install flow control valve in pump housing and tighten to 75 Nm (55 ft. lbs.).
4. Install pressure hose to valve.