Cherokee 4WD L6-4.0L VIN S (1998)
Control Arm Bushing: Service and Repair
REMOVAL
1. Remove the upper suspension arm from axle
2. Position Receiver 7932-1 (J-35581-1), or equivalent over the bushing in the axle and install Bushing Removal/Installer.
3. Remove the bushing by tightening the Long Nut.
NOTE: For two-wheel drive axles and right side on Model 30 axle, do not remove Receiver 7932-1 (J-35581-1), or equivalent at this time.
INSTALLATION
1. Position new bushing, Receiver and Installer on axle.
2. Install the bushing by tightening the Long Nut.
3. Remove tools and install the upper suspension arm.
