Cherokee 4WD L6-4.0L VIN S (1998)
2. Install new O-rings on speed sensor and speedometer adapter if necessary.
3. Lubricate sensor and adapter O-rings with transmission fluid.
4. Install vehicle speed sensor in speedometer adapter. Tighten sensor attaching screw to 2 - 3 Nm (15 - 27 inch lbs.) torque.
5. Install speedometer pinion in adapter.
6. Count number of teeth on speedometer pinion. Do this before installing assembly in housing. Then lubricate pinion teeth with transmission fluid.
Index Numbers On Speedometer Pinion Adapter
7. Note index numbers on adapter body. These numbers will correspond to number of teeth on pinion.
8. Install speedometer assembly in housing.
9. Rotate adapter until required range numbers are at 6 o'clock position. Be sure range index numbers correspond to number of teeth on pinion gear.
10. Install speedometer adapter clamp and retaining screw. Tighten clamp screw to 10 - 12 Nm (90 - 110 inch lbs.) torque.
11. Connect wires to vehicle speed sensor.
12. Lower vehicle and top off transmission fluid level, if necessary
