Cherokee 4WD L6-4.0L VIN S (1998)
Synchronizer Identification
2. If necessary, assemble 1-2 and 3-4 synchronizer hubs, sleeves, springs and key inserts.
3. Install third gear needle bearing onto the output shaft.
4. Install third gear over bearing and onto Output shaft flange.
5. Install third gear synchronizer ring to third gear.
6. Position the 3-4 synchronizer onto the output shaft.
7. Using Adapter 6761 and a shop press, press the 3-4 synchronizer onto the output shaft.
Select 3 - 4 Synchronizer Snap-Ring
8. Select the thickest snap-ring that will fit into the snap-ring groove of the output shaft.
9. Install snap-ring to hold 3-4 synchronizer onto output shaft.