Cherokee 4WD L6-4.0L VIN S (1998)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise and support vehicle.
2. Remove propeller shaft.
Remove Extension Housing Seal
3. Using a suitable seal puller or screw with a slide hammer, remove the extension housing seal.
INSTALLATION
1. Clean seal bore of extension housing of any residual sealer material from original seal.
Install Extension Housing Seal
2. Using Tool Handle C-4171 and Seal Installer 8212, install new extension housing seal so that the seal is located 0 - 0.5 mm (0 - 0.02 inch) to the
face of the extension housing.
3. Install propeller shaft.
4. Check and add fluid to transmission as necessary.
5. Lower vehicle.
