jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Service Manual Corrections|Page 3021 > < Keyless Entry System - Erratic Operation
Page 1
background image

Keyless Entry: All Technical Service Bulletins
Service Manual Corrections

NOVEMBER 1985 000 858
CHEROKEE/WAGONEER
9E
ELECTRICAL

Attention: Workshop, Parts Department

SERVICE MANUAL CORRECTIONS

The MR 244 pages identified below need correction.

Please make the changes or alterations as described.
PROCEDURE

Page C-1 SPECIAL TOOLS

Write in the listing:

Headlight Adapter, Special Tool J-25300-204, just below the Headlight Aimer tool listing in the Special Tool chart.

The Headlight Adapter is a recommended tool. Mark the appropriate column at the right.

Page C-84 STARTING SYSTEM-BOSCH

Voltage Drop

Draw a line through Fig. 100668A and write in the following information:

Battery cable voltage drop must not exceed 0.5V MAX. This is measured with the engine cranking and the ignition control module (ICM) disconnected.

BATTERY CABLE VOLTAGE DROP

Page C-84 STARTING SYSTEM-BOSCH

Place Fig. 84949A, provided with this I.S. Note, over Fig. 84949.

Service Manual Corrections|Page 3021 > < Keyless Entry System - Erratic Operation