Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
Vacuum Advance Unit: Service and Repair
Fig. 6 Distributor components
ELECTRONIC CONTROL MODULE, REPLACE
1.
Remove distributor cap and rotor, then remove two electronic control module attaching screws, Fig. 6.
2.
Carefully lift module upward and disconnect electrical connectors. Note position of connectors for installation. Module electrical connectors must
be connected to the same terminals as removed.
3.
Remove module assembly. Do not remove silicone dielectric grease compound from module or distributor face, if module is to be reinstalled. If a
replacement module is to be installed, silicone dielectric grease compound must be applied to module and distributor base.
4.
Reverse procedure to install. Ensure electrical connectors are installed on the corresponding module terminals as noted during removal.
