jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Powertrain Management > < Exhaust System - Pipe Rattle Against Crossmember
Page 1
background image

Exhaust Pipe: All Technical Service Bulletins
Exhaust System - Pipe Rattle Against Crossmember

MAY 1986
001 030
1984-86 CHEROKEE/ WAGONEER MODELS WITH V-6 ENGINE
14E
ENGINES

Attention: Workshop, Parts Department

THIS I.S. NOTE HAS BEEN REVISED AS INDICATED BY THE REVISION BAR:

EXHAUST PIPE RATTLE

On some 1984-86 Cherokee/Wagoneer models equipped with V-6 engine, the transmission-tocrossmember cushion may sag slightly allowing the exhaust
pipe to contact the crossmember.

If diagnosis indicates the original cushion has sagged, install one of the following replacement cushions.
PROCEDURE

Replace the cushion as described in Chapter BEngines of MR 244. Refer to Rear Engine Mount Removal and Installation.
PARTS INFORMATION

DESCRIPTION

QUANTITY

PART NUMBER

CUSHION, TRANSMISSION-TO-

1

8952 000 139

CROSSMEMBER (with 4WD)

CUSHION, TRANSMISSION-TO-

1

8952 001 313

CROSSMEMBER (With 2WD)

SRT/TIC INFORMATION

OPERATION DESCRIPTION

NUMBER

TIME

TIC

CO. MOUNT, TRANSMISSION-

2051

0.6

2-191

R&R OR REPLACE 1

FILING INFORMATION

Record this I.S. Note on pages B-9 and B-47 of M.R.244 and file it in the manual.

Powertrain Management > < Exhaust System - Pipe Rattle Against Crossmember