Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
NOTE:
Be sure hole (U) and bolt (L) are aligned to the "flat" machined area (V) on the steering column shaft (W).
3.
Position spacer plate (Y) and bolts (N) to frame. Apply a few drops of Loctite 271 (P/N 8129800) to the threads of bolts (N).
4.
Raise the steering gear into position. Tighten bolts (N) to 101 N-m (75 ft.lbs.) torque.
5.
While raising and tilting the steering gear into position, slip the opposite end of the intermediate shaft (P) over the steering gear shaft (Q). Install
