Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
36.
Press the interlock cable lock clamp down until it snaps into place (Figure 28).
37.
Install the floor shifter handle.
38.
Verify that the shift interlock operates properly:
A.
Turn the ignition switch to the LOCK position. Attempt to shift the transmission out of PARK. The shifter should not shift out of PARK.
B.
Turn the ignition switch to the ON position. Attempt to shift the transmission out of PARK. The shifter should not shift out of PARK.
C.
Apply pressure to the brake pedal. Attempt to shift the transmission out of PARK. The shifter should shift out of PARK.
D.
Shift the transmission into DRIVE. With your foot off the brake, attempt to shift into L2 and L1. The shifter should shift into both positions.
E.
Shift the transmission into DRIVE. Attempt to turn the ignition key to the LOCK position. The key should not be able to turn to the LOCK
position. Repeat with the transmission in REVERSE, NEUTRAL, L2 and L1.
F.
Shift the transmission into DRIVE. Attempt to start the engine. The engine should not start. Repeat with the transmission in REVERSE, L2
and L1.
G.
Shift the transmission into PARK. Attempt to start the engine. The engine should start. Repeat with the transmission in NEUTRAL.
H.
Shift the transmission into PARK. Attempt to turn the ignition key to the LOCK position. The key should be able to turn to the LOCK
position.
I.
If the shift interlock fails any of the above tests, he cable must be adjusted, continue with Step 39. If the shift interlock passes all of the
above tests, skip to Step 40.
39.
Adjust the shift interlock cable as follows:
A.
Shift the transmission into PARK and turn the ignition key to the ON position.
B.
Pull up the cable lock button to release the cable.
C.
Compress and release the spring loaded cable adjuster (Figure 28).
NOTE:
If a second cable adjustment is required, insert a .030 pin or shim between the pawl and the park gate (Figure 28) and continue the
adjustment procedure. Remove the pin or shim after the cable has been locked.
D.
Press the cable lock button down until it snaps into position.
E.
Repeat Step 38.
40.
Install the instrument panel lower trim panel (Figure 20).
41.
Install the console air duct and then install the console and secure it with the attaching screws (Figure 19).
42.
Install the console cover (if equipped) and secure it with the attaching screws (Figure 19) and then install the power mirror switch (if equipped).
43.
Install the lamp socket into the transfer case shift bezel and then install the bezel into the console (if equipped) (Figure 19).
44.
Install the lamp socket into the transmission shift indicator bezel and then install the bezel into the console (Figure 19).
45.
Install the transmission shift lever handle.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record notification
service completions and provide dealer payments.
Use the following labor operation number and time allowance:
Install brake pedal shift interlock system
Labor Operation
Time
Number
Allowance
