Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
31.
Compress and release the spring loaded cable adjuster (Figure 6).
32.
Press the interlock cable lock clamp down until it snaps into place (Figure 6).
33.
Install the steering column lock cylinder upper and lower shrouds (Figure 3).
34.
Install the steering column tilt lever if equipped.
35.
Disconnect the instrument panel 48-way electrical connector. (Located under the instrument panel next to the left kick panel.) (Figure 7)
36.
Remove the WHITE w/BLACK tracer wire from cavity E12 of the instrument panel 48-way connector using Miller Tool Wire Terminal Kit #
6680 or a small sharpened screwdriver/paper clip (Figure 7).
37.
Insert the BLACK w/WHITE tracer wire from the supplied wiring harness into cavity E12 of the instrument panel 48-way connector (Figure 7).
38.
Remove the black male 2-way connector from the female connector on the supplied wiring harness.
39.
Remove the locking wedge from the 2-way male connector.
