Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
Selector Shaft: All Technical Service Bulletins
A/T - Gearshift Lever Handle Release Button Service
MARCH 1985 000 636
1984-85 CHEROKEE/WAGONEER 70 SERIES
37E
AUTOMATIC TRANSMISSION
Attention: Workshop, Parts Department
GEARSHIFT LEVER HANDLE RELEASE BUTTON SERVICE
On some 1984-85 Cherokee/Wagoneer 70 Series models with automatic transmission, the release button in the gearshift lever handle may be difficult to
operate.
Service correction is as follows.
GEARSHIFT LEVER HANDLE AND SHIFT PAWL RETURN SPRING
PROCEDURE
1.
Remove the chrome bezel (A) that retains the release button (B) in the gearshift lever handle (E) (see illustration). Use a small screwdriver to pry
the bezel out of the handle.
2.
Remove and discard the original release button (B) (see illustration).
3.
Lubricate surfaces (C & D) of the replacement release button, P/N 8953 000 211, with AMC white spray grease, P/N 899 3887 (US) P/N 1472
(CAN), or equivalent (see illustration).
4.
Install replacement release button and the bezel, (A), in the gearshift lever handle. Be sure the bezel is fully seated in the handle.
NOTE:
Install the replacement release button with the (D) side of the button facing downward.
5.
Unsnap the gearshift indicator bezel. Lift the bezel upward and secure it to the shift lever handle for access to the shift lever mechanism.
6.
Remove and discard the original shift pawl return spring, (F), (see illustration).
7.
Install replacement shift pawl return spring, P/N 8953 003 350.
8.
Thoroughly lubricate all the moving parts of the gearshift lever mechanism with AMC white spray grease, P/N 899 3887 (US) P/N 1472
(CAN) or equivalent.