jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Differential Lock > < Clutch Master Cylinder - Service
Page 1
background image

Differential Case: Technical Service Bulletins
Front Axle - Vent Hose

JANUARY 1985 000 385
CHEROKEE/WAGONEER 70 SERIES
29E
FRONT AXLE

Attention: Workshop, Parts Department

FRONT AXLE VENT HOSE

The front axle vent hose may rub against the intermediate steering shaft U-joint on some 1984 and 1985 70 Series vehicles built prior to body sequence
number 61601.

Move and secure the vent hose away from the steering shaft U-joint as outlined in the following procedure.
Procedure

1.

Inspect the front axle vent hose. If damaged, replace the hose with a 91 cm (36-in) length of replacement hose, P/N 812 5823.

2.

Secure the vent hose to the driver side frame sill with tie strap, P/N 323 0270, as follows:

VENT HOSE AND SILL WITH TIE STRAP

a.

Loop the tie strap (A) through the two holes in the sill that are located just below the steering shaft U-joint (see illustration).

b.

Move the vent hose (B) forward.

c.

Secure the vent hose to the sill with tie strap (A) as shown.

Parts

DESCRIPTION

QUANTITY

PART NUMBER

STRAP, Tie

1

323 0270

HOSE, Axle Vent (Bulk)

91 cm (36-in)

812 5823

per/vehicle

S.R.T. Information

OPERATION DESCRIPTION

TIME

NUMBER

TIC

CO. HOSE, FRONT AXLE VENT
(Move and Secure)

0.3

2999

3-208

Filing Instructions

Record this I.S. Note on page G-104 and file it in your M.R. 244 binder.

Differential Lock > < Clutch Master Cylinder - Service