Cherokee 4WD V6-173 2.8L VIN W 2-bbl (1985)
Seals and Gaskets: Service and Repair
Axle Shaft Seal
REMOVAL
1. Raise and support vehicle, then remove wheel and brake drum.
2. Working through holes in axle shaft flange, remove brake support plate attaching nuts.
3. Using a suitable slide hammer type puller, remove axle shaft from housing.
Fig. 1 Removing retaining ring from axle shaft
Fig. 2 Replacing axle shaft bearing
DISASSEMBLY
1. Position axle shaft in a vise.
2. Drill a 1/4 inch hole approximately 3/4 of the way through bearing retaining ring, then chisel a deep groove in ring and remove from axle shaft.
3. Using tool J-23674 or equivalent, press bearing from shaft.
4. Remove seal, gasket and retainer plate from axle shaft.
ASSEMBLY
1. Lubricate seal, then install retainer plate, gasket and seal onto axle shaft.
2. Lubricate bearing, then using tool J-23674 and a suitable press, install bearing and retaining ring onto axle shaft. Ensure bearing and ring are
properly seated against axle shaft shoulder.
INSTALLATION
1. Clean axle housing bearing bore, then apply a thin coat of grease to outer diameter of bearing cup.
2. Install axle shaft, then alternately torque brake support plate attaching nuts to 32 ft. lbs.
3. Install brake drum and wheel, then lower vehicle.
