Cherokee 4WD LHD L6-4.0L VIN S (2001)
position and the left multi-function switch control stalk is pulled toward the steering wheel to a momentary position, the headlamp high beams will
be selected until the control stalk is released. The hazard warning switch is controlled by the hazard warning switch button. Sliding the hazard
switch button to the left detent position will cause the switch circuitry to activate the hazard warning lamps, and sliding the button to the right
detent position will deactivate the hazard warning lamps.
The turn signal circuitry operates on battery current receive through a fused ignition switch output (run) circuit so that it will only operate when the
ignition switch is in the ON position. The hazard warning and headlamp beam select circuitry operates on battery current received through a fused
B(+) circuit so that it will remain operational, regardless of the ignition switch position. The turn signal and hazard warning circuitry of the left
multi-function switch provides a select signal input to the combination flasher, then directs the combination flasher output to the proper lamp
circuits. The headlamp beam select circuitry of the left multi-function switch directs the outputs of the headlamp switch through fuses in the
Junction Block (JB) to the proper headlamp high or low beam circuits. Refer to the owner's manual in the vehicle glove box for more information
on the features, use and operation of the left multi-function switch.