Cherokee 4WD LHD L6-4.0L VIN S (2001)
16. Remove rear bearing from the pinion shaft with Puller/Press C-293-PA and Adapters C-293-40 (Fig. 67).
17. Remove depth shims from the pinion shaft and record the thickness of the shims.
INSTALLATION
NOTE: A pinion depth shim/oil slinger is placed between the rear pinion bearing cone and the pinion head to achieve proper ring gear and pinion
mesh. If ring gear and pinion are reused, the pinion depth shim/oil slinger should not require replacement. Refer to Adjustment (Pinion Gear Depth) to
select the proper thickness shim/oil slinger if ring and pinion gears are replaced.
1. Apply Mopar Door Ease or equivalent lubricant to outside surface of bearing cup.
2. Install the pinion rear bearing cup with Installer D-146 and Driver Handle C-4171 (Fig. 68) and verify cup is seated.
3. Apply Mopar Door Ease or equivalent lubricant to outside surface of bearing cup.
