CJ-7 L4-150 2.5L VIN U 1-bbl (1983)
Transfer Case Actuator: Service and Repair
Fig. 5 Axle vacuum motor & shift fork assembly
Fig. 6 Removal & installation of shift fork assembly
1983-87 MODELS WITH SELEC-TRAC
REMOVAL
1. Raise and support front of vehicle, then drain lubricant from front axle.
2. Disconnect vacuum lines from shift motor.
3. Remove axle housing cover, shift motor and shift fork as an assembly.
DISASSEMBLY
1. Remove shift fork to pivot pin retaining E-clip.
2. Disconnect shift fork pivot from shift motor shaft by threading pivot out of shaft.
3. Remove shift fork assembly from pivot pin.
4. Remove shift motor retaining nut and remove shift motor from axle housing cover.
