CJ-7 L6-258 4.2L VIN C 2-bbl (1982)
4. Install trunnion housing on shaft, then seat protective boot in housing and install remaining boot retaining strap. Make sure boot is fully seated in
housing and strap is seated in strap groove in boot before tightening.
5. Place shaft in arbor press and start trunnion pin in bore. Carefully press pin into bore until pin is centered in shaft to within 0.006 inch. Pin must
project an equal amount from each side of shaft pin bore. If pin is not centered within 0.006 inch, propeller shaft vibration may result.
6. Install trunnion ball washer on pin and install trunnion ball and needle bearings on pin.
7. Install trunnion cap washer and trunnion cap on pin.
8. Move housing forward and over ball and trunnion assembly. Make sure assembly is properly and completely seated in housing.
9. Install gasket and plate on housing and bend plate lock tabs into housing slots to retain plate and gasket.