Comanche 2WD L4-150 2.5L VIN E TBI (1989)
Engine Mount: Service and Repair
Front Mount
Fig. 1 Front Engine Mount Replacement
1.
Disconnect battery ground cable.
2.
Remove through bolt retaining nut (1), Fig. 1. Do not remove through bolt at this time.
3.
Remove engine mount upper retaining bolt (3), then raise and support vehicle.
4.
Support engine with a suitable jack, then remove engine mount lower retaining nut (4) and through bolt (2). On six cylinder engines, it may be
necessary to remove the air pump and hose assembly to allow removal of through bolt.
5.
Raise engine slightly and support, then remove engine mount (5).
6.
Reverse procedure to install noting the following:
a.
On all except 1989-91 models, torque all nuts and bolts to 32 ft. lbs.
b.
On 1989-92 torque engine mount retaining bolts to 30 ft. lbs. and the through bolt to 48 ft. lbs.
