jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Recall - Oxygen Sensor and Catalytic Converter|Page 2054 > < Recall - Oxygen Sensor and Catalytic Converter|Page 2052
Page 3
background image

Use penetrating oil if necessary.

2.

On Wrangler (YJ) vehicles: Support the transmission and remove the skid plate.

3.

Place a block of wood against the rear of the converter and drive the converter forward to disengage the alignment tab on the converter pipe
from the alignment slot on the muffler.

NOTE

If the converter does not move forward, it may be necessary to heat the converter to muffler connection with an oxyacetylene torch until the
metal becomes cherry red.

4.

Twist the converter back and forth to separate it from the muffler.

5.

Install the new converter into the muffler until the alignment tab is inserted into the alignment slot.

6.

Using the provided gasket, nuts and bolts, attach the converter to the front exhaust pipe. Do not tighten the bolts.

7.

Install and tighten the new exhaust pipe clamp, at the muffler to converter connection, to 40 ft-lbs (57 N-m).

8.

Tighten the converter to front exhaust pipe bolts to 25 ft-lbs (34 N-m).

9.

On Wrangler (YJ) vehicles: Install the skid plate.

10.

Lower vehicle.

Report/Reimburse, Parts Return, Vehicle Not Available

Completion Reporting and Reimbursement

Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.

Use the following labor operation number and time allowance:

Labor Operation Number

Time Allowance

25617182

0.8 Hours

Replace oxygen sensor and catalytic converter

Add the cost of the recall parts package plus applicable dealer allowance to your claim.

Parts Return

Removed catalytic converters must be returned to the Warranty Material Return Center.

Note

See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing and material return instructions.

Vehicle Not Available

If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:

Chrysler Corporation 429-10-04
P.O. Box 1919
Detroit, Michigan 48231-1919

Following the above procedures will expedite the processing of your claim.

If you have any questions or need assistance in completing this action, please contact your Zone Service Office.

Owner Letter

EMISSIONS RECALL TO REPLACE YOUR VEHICLE'S OXYGEN SENSOR AND CATALYTIC CONVERTER

Dear Jeep(R) Vehicle Owner:

Chrysler Corporation has determined that some 1989 and 1990 Jeep(R) Cherokee, Comanche and Wrangler vehicles equipped with a 2.5L engine, may
be in violation of Federal Emissions Standards.

Recall - Oxygen Sensor and Catalytic Converter|Page 2054 > < Recall - Oxygen Sensor and Catalytic Converter|Page 2052