Comanche 2WD L4-150 2.5L VIN E TBI (1989)
a.
Pull back splash shield and locate fuel tank vent valve in fuel vent line in right rear fender well of vehicle (Figure 6).
b.
Disconnect clamp at small end of boot and pull boot from vent line.
c.
Using a sharp utility knife, slice side of rubber boot and remove it from the vent valve. Be careful not to cut the vent valve.
d.
Install provided boot on vent valve.
Note:
A few drops of automatic transmission fluid (ATF) may be used to aid boot installation.
e.
Install small end of boot on fuel vent line and install clamp.
f.
Reinstall splash shield.
31.
Lower vehicle.
32.
Connect the negative battery cable.
33.
Refill the cooling system.
34.
Continue with Step H in the "Emissions Components - Removal/Installation" section.
Emissions Components - Removal/Installation
D.
REPLACE OXYGEN SENSOR:
Warning:
Exhaust manifold becomes very hot during engine operation. Make sure engine has cooled sufficiently before attempting oxygen sensor replacement.
