Comanche 2WD L4-150 2.5L VIN E TBI (1989)
NOTE:
Do not use solvents or lubricants on threads.
5.
Install provided oxygen sensor. Tighten to 22 ft.lbs. (30 N-m).
6.
Connect oxygen sensor electrical connector.
Owner Letter
EMISSION RECALL -- Oxygen Sensor
Dear Chrysler Corporation Vehicle Owner:
It has been determined that the oxygen sensor on certain 1989 Jeep(R) Cherokee, Comanche and Wrangler models equipped with a 2.5L engine may be
susceptible to failure. Failure of the oxygen sensor may cause your vehicle to be in violation of Federal Emissions Standards. For this reason, we are
asking you to return your vehicle, identified by the Vehicle Identification Number on the form, to your dealer for a special service repair. The service
and required parts as described in this letter will be provided free of charge.
The needed instructions have been sent to all Jeep & Eagle dealers. The service will not hurt your engine performance or fuel economy. To obtain this
service:
^
Contact your dealer to make a service appointment
^
Take the enclosed Owner Notification Form with you at the time of your appointment and give it to your dealer. The form identifies the vehicle and
the service that is required.
^
The dealer will replace the oxygen sensor. The service will take about one-half hour to complete. However, additional time may be required
depending on how dealer appointments are scheduled and processed.
In order to ensure your full protection under the emission warranty made applicable to your vehicle under Federal law, and your right to participate in
future recalls, it is recommended that you have your vehicle serviced as soon as possible. Failure to do so could legally be determined to be a lack of
proper maintenance of your vehicle. Further, without this repair, your vehicle may fail a state or local emission inspection test.
If you have any problem obtaining the service, please call the Chrysler Customer Center, toll free, at 1-800-853-1403. A representative will assist you in
getting your vehicle repaired. If you are still unable to obtain the repair as described in this letter within a reasonable time, you may also contact the
Manufacturers Operations Division of the Environmental Protection Agency (6405J), 401 M Street, S.W., Washington, D.C. 20460.
We regret any inconvenience which this action may cause you, but trust that you understand our interest in clean air and your continuing satisfaction with
our product. Thank you for your prompt attention to this important matter.
