Comanche 2WD L4-150 2.5L VIN E TBI (1989)
1.
Locate and remove rubber vacuum hose near rear of intake manifold, which connects the metal transfer case vacuum tube to the vacuum
port on the intake manifold (Figure 9).
2.
Install provided transfer case vacuum hose (Figure 9).
G.
REPLACE FUEL TANK VENT VALVE BOOT (YJ Vehicles Equipped With Steel Fuel Tank Only):
1.
Raise vehicle on hoist.
2.
Pull back splash shield and locate fuel tank vent valve in fuel vent line in right rear fender well of vehicle (Figure 10).
3.
Disconnect clamp at small end of boot and pull boot from vent line.
4.
Using a sharp utility knife, slice side of rubber boot and remove it from the vent valve. Be careful not to cut the vent valve.
5.
Install provided boot on vent valve.
Note:
A few drops of automatic transmission fluid (ATF) may be used to aid boot installation.
6.
Install small end of boot on fuel vent line and install clamp.
7.
Reinstall splash shield.
8.
Lower vehicle.
H.
INSTALL RECALL COMPLETION LABEL:
1.
With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.
