Comanche 2WD L6-242 4.0L VIN S MFI (1992)
Speed Control Servo: Service and Repair
1. Disconnect battery ground cable.
2. Disconnect vacuum hose, then the electrical connector from servo.
3. Remove two nuts from mounting bracket, then pull servo away from bracket.
4. Remove, then discard push nuts from servo studs.
5. Pull speed control cable away from servo just far enough to expose cable retaining pin, then remove pin.
6. Reverse procedure to install. Hold throttle in the full open position while installing pin. Torque both attaching nuts to 50 inch lbs.
