Comanche 2WD L6-242 4.0L VIN S MFI (1992)
Crankshaft Position Sensor: Testing and Inspection
Crankshaft Position Sensor Electrical Connector
NOTE:
To perform a complete test of the CPS and it's circuitry, refer to the appropriate Powertrain Diagnostic Chart. To test the CPS only, refer to the
following:
PROCEDURE
1.
Near the rear of intake manifold, disconnect (CPS) pigtail harness connector from main wiring harness.
2.
Place an ohmmeter across terminals A and B. The meter reading should be open (no resistance). Replace sensor if any resistance is indicated.